Chapter 2: Installation and configuration
LaserSense Nano Aspirating Smoke Detector Installers Handbook 25
Auto calibration
Auto calibration automatically starts a new FastLearn cycle when the detector is
powered up. This may be disabled if the previous settings need to be retained.
Final installation
Once the power and signal connections are made, place the detector cover onto
the unit and secure the cover to the unit using the cover mounting screw.
Note: The detector is designed solely for operation with the front cover securely
fitted using the cover mounting screw.
Removing the detector
Removing the detector is the reverse of the installation process, disconnecting
the pipework and wiring connections installed in the unit.
To Next Page
Loading...
Need help?
General
