Effekta AX M2 Series - Operation; Device Power On; Firmware and Data Management

Innovating po we r.
Operation – Page 95
Solar inverter | V1.7
10 Operation
10.1 Switching on device
Step 1
If the device has been installed
properly and the batteries are
connected properly, press the
on/off button to switch on the
device .
10.2 Update inverter firmware (if recommended)
Step 1
Please plug the USB storage in the USB
port ( ).
Press the button for 3 seconds
to get to the USB function setting mode .
Step 2
Press the button
.
This function updates the inverter
firmware .