U S E R M A N U A L E P S - D
Technical specifications and data are subject to change without any prior notice.
31
Battery Off:
Every 90 minutes the unit checks if the batteries are connected. If the alarm is
active and the batteries are connected and the battery breaker is on, then the fault
might lay with the batteries. If the conditions of the batteries are very poor, the
unit can perceive them as not connected.
Turn on the battery breaker, check the status of the batteries.
Ext Firealarm:
If the fire alarm input on JP2 has been activated, the unit will activate the fire
alarm operation. The unit will then activate all the outputs on mains or on battery
mode, depending upon the selected setting.
Remove the activation on JP2.
Troubleshooting
The load is connected, but the lights aren’t activated:
Make sure that the correct input are connected and has appropriate voltage.
Make sure that the output fuses are intact.
Shut down the electronics and the load should activate on mains.
The Display turns on but is blank:
Shut down the unit and make sure that the processor is mounted firmly in its
place.
Restart the unit
To Next Page
Loading...