How-To: Using the IQ-501 with the Fiery server
8
Fiery Calibration from Fiery Color Proler Suite (FCPS)
4. Select the Fiery server that you wish to calibrate.
Click the “+” symbol to discover the Fiery server
if it is not listed.
5. Select Recalibrate and click Next.
In this exercise we are recalibrating an existing
calibration set.
1. Start Fiery Color Proler Suite.
If you have not purchased and installed a license
for FCPS you will need to run FCPS in Demo
mode for Fiery Calibration as follows.
2. Select Run in Demo mode.
This step will not be necessary if the license is
installed and activated correctly.
3. Click on the Calibrator icon.
Note that Calibrator and Inspect are the only
two modules that allow full capabilities without
a license. Inspect is not discussed in this
document.
To Next Page
Loading...
Need help?
General
