18
NOTE: Letters in (parentheses) refer to the PARTS IDENTIFIER on page 2 and/or the PARTS ASSEMBLY on page 3. Use as needed for clarification.
ADJUSTING THE RAIL ANGLE
50. To raise or lower the Rail (K, X) angle, stand alongside the Tower (A). Reach on top of the
Tower (A) to the Up/Down Switch (ZY). Micro switches at the upper and lower ranges of
resistance (4 degrees and 34 degrees respectively) halt movement at upper and lower
resistance limits. Any time you release the Up/Down Switch (ZY), movement ceases.
51. Any time you wish to use the glideboard free from the pulley cable assembly, simply unfasten
and release the center cable pulley snap hook.
52. Snap the center cable pulley to one of the LAT Bar pulley Locator brackets as shown.
50
51
52
To Next Page
Loading...
Need help?
General