EasyManuals Logo

EFI Pro 30f User Manual

EFI Pro 30f
57 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
Printer Setup
Document ID: OMM-00174 Rev. D Pro 30f Operations Guide 33
This chapter describes set-up procedures for the EFI Pro 30f Wide Format Printer. Perform the tasks in this chapter when
setting up the EFI Pro 30f Wide Format printer for operation.
EFI highly recommends conducting all routine maintenance before starting up the machine. This helps improve the
quality of the output as well as the safety of the operator. Below is a check list of activities that operators should do prior
to operation of the machine.
Turn on the ventilation and lighting systems inside the printing room.
Check for and clear any traces of ink spillage on the machine and the floor.
Check whether the waste container is already full and empty it if necessary
Make sure there is no media or material on top of the print bed, specifically along the path of the carriage during printing.
1. Ensure that all E-Stops are OFF. The printer is in an alarm state until/unless the E-Stops are deactivated.
5.0 Printer Setup
5.1 Printer Power On
Figure 5-1 Emergency Stop Push Button Positions and Locations
Front of Printer Rear of Printer
E-stop ON
E-stop OFF

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EFI Pro 30f and is the answer not in the manual?

EFI Pro 30f Specifications

General IconGeneral
BrandEFI
ModelPro 30f
CategoryPrinter
LanguageEnglish

Related product manuals