Printer Operations
Document ID: OMM-00174 Rev. D Pro 30f Operations Guide 48
To recover from these errors, perform the following:
1. Remove the safety stop obstruction, if applicable
2. Ensure all red e-stops are released
3. Close the EFI Pro 30f GUI software
NOTE: If required, use Windows Task Manager to force close "Print UI for EFI Printer"
4. Push an e-stop.
5. If applicable, manually move the carriage (by hand) to the home position, above the purge tray.
6. Release the e-stop.
7. Push the green reset button.
8. Start the EFI Pro 30f GUI software.
NOTE: If software errors appears or printer does not respond to GUI commands, repeat this process.
Figure 6-4 Close EFI Pro 30f GUI Software
To Next Page
Loading...
