Ink System
Document ID: OMM-00174 Rev. D Pro 30f Operations Guide 50
This chapter describes basic ink replenishing procedures for the EFI Pro 30f Wide Format Printer.
1. Carefully remove the ink container cap and ensure that no ink spills into the ink supply compartment.
NOTE: It may be necessary to clean the tubes and float connected to the cap.
2. Carefully remove the empty ink container from the compartment and dispose of it in the appropriate manner.
NOTE: If planning to transfer and use remainder ink in the future, tighten the cap on the old bottle and store it
until there is space for the remainder ink in the newly installed ink bottle.
3. Open a new container and put it in place of the spent container.
7.0 Ink System
Caution: Wear protective gloves and eye protection when replenishing ink.
Caution: When replenishing White Ink ensure that the “White Ink Bottle Recirculation” box is
UNCHECKED on the Test Printer System tab prior to removing the ink line from the ink
container. Failure to do so will cause a quantity of white ink to spray from the recirculation
line. Recheck the “White Ink Bottle Recirculation” box after replenishing white ink. (See
Figure 7-1)
To Next Page
Loading...
Need help?
General
