Efka DA320G5351 - Page 35

EFKA DA320G5351
37
Supplier Level
Code no. 311 with control operation
Code no. 3112 with control panel operation
Parameter Designation Unit Limits Preset for Ind.
max min 100Ω 220Ω 680Ω 1000Ω
323 FLn 0 = Sewing foot is not lifted after power On 1 0 0 0 0 0 A
1 = Sewing foot is lifted after power On
This function is enabled only if Teach in is On
324 ti 0 = Teach in Off 1 0 0 0 0 0 A
1 = Teach in On
Teach in programming is possible only with V820.
Execution of pattern is possible without V820.
325 cti Erasing all TEACH IN data
- Input code number 3112 after power On
- Press the E key
- Input parameter 325
- Press the E key
- Input 3112
- Press the P key
- The display briefly shows “deleted“, and a short
acoustic signal is issued
- Press the P key - all TEACH IN programs have
been erased!
326 EPE Disabling the P and E keys on the control panels 3 0 3 3 3 3 A
and the P key on the control
0 = P and E keys are Off
1 = P key is On and E key is Off
2 = P key is Off and E key is On
3 = P and E keys are On
327 EPm Disabling the + / - keys on the control panels 1 0 1 1 1 1 A
0 = + and – keys are Off
1 = + and – keys are On
328 ob Disabling the E, +, - and >> keys on the control 1 0 1 1 1 1 A
0 = E, +, - and >> keys are Off
1 = E, +, - and >> keys are On
332 FLd 0 = The settings of parameters 203 and 204 1 0 0 0 0 0 A
determine the sewing foot lift function.
1 = If sewing foot lifting is stored in the seam,
the solenoid will be fully activated based on
the settings of parameter 333, and pulsed
based on the settings of parameter 334.
333 t4_ Time of full power of sewing foot lifting ms 600 0 0 0 0 0 A
334 t5_ Holding power for sewing foot lifting % pa. 298 1 85 85 85 85 A
1...100%
1%

low holding power
100%  high holding power
401 EEP Immediate storage of all changed data 1 0 0 0 0 0 A
- Input code number 3112 after power On
- Press the E key
- Input parameter 401
- Press the E key
- Set display from 0 to 1
- Press the E or P key
- All data are stored
500 Sir Recall of Fast Installation Routine (SIR)
(see description in chapter 2 on page 5!)