Eighteeth CuringPen - Setting; Selecting memory

Błąd! Użyj karty Narzędzia główne, aby
zastosować 标题 1 do tekstu, który ma się tutaj pojawić. Błąd!
Użyj karty Narzędzia główne, aby zastosować 标题 1 do tekstu,
który ma się tutaj pojawić.
Page 12 / 30
6.Setting
6.1 Selecting memory
M0
1500mW/cm²
15s
Memory Change
There are 6 built-in memory programs, namely
M0, M1, M2, RAMP, PULSE, Detect. Press setting
key to change the memory during standby state
Curing Power
mW/cm ²1500
Light intensity setting
The memory programs of M0, M1 and M2 can be
customized to 2300mW/cm
2
, 1500mW/cm
2
or
1000mW/cm
2
. Long Press “S” to enter the light
intensity setting menu, then press “S” to change
or press main switch to confirm and exit.
On the light intensity setting menu, long press “S”
to enter the time setting menu.
NOTE
⚫ The light intensity of RAMP, PULSE and
Detect memory programs are built-in,
and the user cannot modify the
settings.
Curing Time
Sec05
Curing Time setting
In the curing time setting menu, press “S” to
select different times. The time selection is
different under different light intensity:
light
intensity(mW/cm²)
time selection(sec)
2300
01,02,03
1500
05,10,15,20
1000
05,10,15,20
600
10,15,20,25
Long press “S” or short press to exit the setting.
The current memory program automatically saves
the setting parameters.