4.1 Installation of heating
needle
Make sure one of the dents on heating
needle aligning the small triangle on
handpiece, push till to position.
Holding the grey shell to pull the heating
needle out from the handpiece.
The heating needle can be installed in
any one of 6 orientations. Pull it out
from handpiece then can be installed in
other orientations.
➢ To remove the heating needle, wait
for it to cool down, it takes about 2-3
seconds, and real-time temperature
will show on the screen.
➢ Even the heating needle cool down
already, we strongly recommend not
touch the metal part on heating
needle, there is a risk of heat injure or
damage the heating needle, hold the
grey shell to remove.
4.2 Installation of adapter
Plug the head into the base if they are
separated in the package.
To Next Page
Loading...
