Attachment
Guidance and manufacturer’s declaration – electromagnetic emissions
The equipment is intended for use in the electromagnetic environment specified below. The
customer or the user of the equipment should assure that it is used in such an environment.
Electromagnetic environment - guidance
RF emissions CISPR 11 Group 1 Class B
The equipment uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
Guidance and manufacturer’s declaration – electromagnetic immunity
The equipment is intended for use in the electromagnetic environment specified below. The
customer or the user of the
equipment should assure that it is used in such an environment.
Immunity test
IEC 60601 test
level
Compliance level
Electromagnetic
environment - guidance
Electrostatic
Discharge (ESD)
IEC 61000-4-2
+/-8 kV contact
+/-15kV air
+/-2, 4, 6 & 8kV
contact
+/-2, 4, 8, & 15 kV
air
Floors should be wood,
concrete or ceramic tile. If
floors are synthetic, the r/h
should be at least 30%
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
30A/m 3 & 30A/m
Power frequency magnetic
fields should be that of a
typical commercial or
hospital environment.
Guidance and Manufacturer’s Declaration – Electromagnetic Emissions
The equipment is intended for use in the electromagnetic environment specified below. The
customer or user of the equipment should ensure that it is used in such an environment.
Immunity
test
IEC 60601
test level
Compliance
level
Electromagnetic environment -
guidance
Page 43 / 51
To Next Page
Loading...