The dampening option calculates the average load based on the measurements taken
over a given number of seconds (here called T). When measuring begins, the first
reading will show after about one second. After two seconds, the display will show a
reading based on the average of the readings from the first two seconds. After three
seconds, the displayed reading will be the average of the first three seconds. This will
continue for the first T seconds.
After T seconds and onward, the display will show an updated reading about once per
second based on the average of the readings from the previous T seconds. The
interval T can only be set in the factory. It is set as standard to 5 seconds but can be
set to any number of seconds according to the customer's request.
4.10 Connector Cables
5 Pin Sealed Circular Connector:
RS-232
C. RS-232
D. GND RS-232
E. –
RS-485:
A. NO
B. NO
C. A (RS-485)
D. A (RS-485)
E. GND
To Next Page
Loading...
