2. Basic Operation
Basic operation of Ron systems and helpful tips and tricks
Before operation, be sure the shackles you intend to use are appropriate for the
system (see shackle specification table). Press the key to turn the system on. The
display will read BATT, then the percentage of remaining battery life of the indicator
and then the load cell, followed by the unit of measurement.
M. TON (Metric Tons)
S. TON (Short Tons, American tons, 2000 Lbs)
LBS
K.NTON (Kilo Newton)
DECA.N (Deca Newton)
N.WTON (Newton)
KG
The current weight value will then be displayed.
Before loading the system, press until ZERO is displayed.
The system should then read GROSS then 0.
Once use of the system has been completed, press the key to power down.
Return both the load cell and indicator to their carrying case or another appropriate
safe place of storage.
2.1 - General operation of the keyboard:
When pressing a key, the system responds with a short audio signal (a beep) followed by
a change to the display. For example, if one presses the key, MAX will be displayed.
The key should be pressed continuously until the beep is heard. Exceptions are turning
the system on or off which does not require a long press. Also, when several keys are
pressed in sequence as part of a code during calibration, the visual signal will only appear
To Next Page
Loading...