To move to the next load cell press the Up or Down arrow keys (▲▼)
In this way you can change any of the load cells to be active or inactive. To exit press
Menu/OK. This display will read OK and then return to the standard measuring
screen.
Zeroing load cells:
Use the ESC key to cycle through the load values of the load cells until you reach that
of the cell to be zeroed. Press ZERO. The screen will read ZERO, GROSS, then
revert to the main measuring screen with a 0 value indicated.
Calibration:
Calibration is done according to instruction in the Calibration section. Calibration for
each of the load cells is done separately. In order to calibrate a specific load cell,
deactivate all the other load cells that are designated to your multi-cell system. After
completing the calibration, do not forget to reactivate the load cells that you require
for weighing.
To Next Page
Loading...
