To Next PageTo Next PageWhat to do if my EINHELL Water Pump does not start?
If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
Why does my EINHELL GC-DP 5010 G Water Pump switch off after briefly running?
Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
What to do if my EINHELL Water Pump does not pump water?
If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
Why EINHELL GC-DP 5010 G has insufficient pumping rate?
An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.
What to do if my EINHELL GC-DP 5010 G does not cut out?
If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.
General| Brand | EINHELL |
|---|---|
| Model | GC-DP 5010 G |
| Category | Water Pump |
| Language | English |
Pump must be powered via an earth-leakage circuit breaker (RCD) with a rated fault current of no more than 30 mA.
Illustrates the main components of the pump, including handle, hose connection, intake cage, and floating switch.
Details the components included with the pump, such as the pump itself and hose connectors.
Details how to install the pump, either stationary with rigid pipe or flexible hose.
Important safety advice for installation, such as not hanging the pump by the discharge line or power cable.
Instructions for connecting the pump to the mains supply, emphasizing earthing pin plug and socket requirements.
Essential checks before operating the pump, including secure setup, correct connections, and power supply.
Guide on adjusting the floating switch for automatic ON/OFF operation and preventing dry running.
Instructions for manual operation, emphasizing supervision to prevent dry running.
Covers essential maintenance tasks like unplugging, cleaning after use, checking the floating switch, and removing debris.
Step-by-step guide to dismantle the pump's bottom part to clean the paddle wheel.
Information on required data and where to find prices and information for ordering spare parts.
Instructions for reporting equipment defects online, including necessary details and questions to answer.
