EINHELL TC-TS 2225 U User Manual

GB
- 56 -
b) Do not use an electric power tool if the switch is defective.
An electric power tool that cannot be switched on or off is dange-
rous and must be repaired.
c) Pull the plug out of the socket and/or remove the removab-
le battery pack before making any adjustments to the tool,
changing plug-in tool parts or putting the power tool down.
These precautions will prevent the power tool starting acciden-
tally.
d) Keep unused electric tools out of the reach of children. Do
not allow people who are not familiar with the power tool or
who have not read these instructions to use the power tool.
Electric tools are dangerous if they are used by inexperienced
people.
e) Look after power tools and plug-in tools with care. Check
that moving parts function correctly and do not jam, and
whether any parts are broken or damaged such that they
adversely aff ect the function of the power tool. Have da-
maged parts repaired before you use the power tool. Many
accidents are caused by poorly maintained electric tools.
f) Keep cutting tools sharp and clean. Carefully maintained cut-
ting tools with sharp cutting edges will jam less and are easier to
control.
g) Use the power tool, plug-in tools, etc. as set out in these
instructions. Take account of the conditions in your work
area and the job in hand. Using electric tools for purposes
other than the one for which they are designed can result in dan-
gerous situations.
h) Keep the handles and grip surfaces dry, clean and free
from oil and grease. If the handles and grip surfaces are slip-
pery, it will not be possible to operate and control the power tool
safely in unforeseen situations.
Anl_TC_TS_2225_U_SPK7_Rewe.indb 56 24.03.2020 10:29:24

EINHELL TC-TS 2225 U Specifications

General

Product color	Red, Silver
Quick stop function	Yes
Idle speed	4250 RPM
Cutting height @ 45°	55 mm
Cutting height @ 90°	80 mm
Cross stop tilt angle range	-45 - 45 °
Input power	1800 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Saw blade type	Single
Number of teeth	48
Number of saw blades	1
Package depth	615 mm
Package width	715 mm
Package weight	28600 g

Weight and Dimensions

Depth	750 mm
Width	610 mm
Height	380 mm
Weight	17460 g
Table depth	555 mm
Table width	580 mm
Bore diameter	30 mm
Blade diameter	254 mm
Height adjustment range	0 - 80 mm