EINHELL TC-TS 2225 U User Manual

GB
- 61 -
knotted or twisted workpiece is instable and will lead to the mi-
salignment of the kerf with the saw blade, and jamming and kick-
back.
i) Never saw several workpieces stacked one on top of the
other or one after the other. The saw blade could catch one or
more parts and cause kickback.
j) Do not start the saw if the saw is in the workpiece. If the saw
blade is jammed it may lift the workpiece and cause kickback
when the saw is restarted.
k) Keep the saw blades clean, sharp and adequately set. Ne-
ver use bent saw blades or saw blades with cracked or bro-
ken teeth. Saw blades which are sharp and properly set minimi-
ze jamming, blockages and kickback.
4) Safety information for the operation of bench-type circular
saws
a) Switch off the bench-type circular saw and disconnect it
from the mains power supply before you remove the table
insert, change the saw blade, adjust the splitter or the saw
blade safety guard and when the machine is left unatten-
ded. Precautions are intended to help prevent accidents.
b) Never leave the bench-type circular saw running unatten-
ded. Switch off the power tool and do not leave it before it
has come to a complete standstill. A saw which is left running
unattended is an uncontrolled danger.
c) Set the saw up at a location which is level and well-lit and
where you can stand steadily and keep your balance. The
location where you set it must provide suffi cient space for
you to handle your larger workpieces easily. Untidiness, unlit
work areas and uneven, slippery fl oors can lead to accidents.
d) Remove wood sawings and sawdust regularly from under
the saw table and/or from the dust extractor. Accumulations
of sawdust are combustible and can self-ignite.
e) Secure the bench-type circular saw. If the bench-type circular
saw is not properly secured, it could move or topple over.
Anl_TC_TS_2225_U_SPK7_Rewe.indb 61 24.03.2020 10:29:24

EINHELL TC-TS 2225 U Specifications

General

Product color	Red, Silver
Quick stop function	Yes
Idle speed	4250 RPM
Cutting height @ 45°	55 mm
Cutting height @ 90°	80 mm
Cross stop tilt angle range	-45 - 45 °
Input power	1800 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Saw blade type	Single
Number of teeth	48
Number of saw blades	1
Package depth	615 mm
Package width	715 mm
Package weight	28600 g

Weight and Dimensions

Depth	750 mm
Width	610 mm
Height	380 mm
Weight	17460 g
Table depth	555 mm
Table width	580 mm
Bore diameter	30 mm
Blade diameter	254 mm
Height adjustment range	0 - 80 mm