EINHELL TC-TS 2225 U User Manual

GB
- 62 -
f) Remove all adjusting tools, residual wood, etc., from the
bench-type circular saw before you switch it on. Distractions
or possible jams can be dangerous.
g) Always use saw blades of the correct size and with a suita-
ble mounting hole (diamond-shaped or round). Saw blades
that do not match the mounting parts of the saw will not rotate
truly and will result in a loss of control.
h) Never use damaged or the incorrect saw blade assembly
material such as, e.g. fl anges, washers, screws or nuts. This
saw blade assembly material has been specially designed for
your saw, for safe operation and optimum performance.
i) Never get onto the bench-type circular saw and never use
the bench-type circular saw as a step stool. Serious injuries
could occur if the power tool topples over or if you come into con-
tact with the saw blade accidentally.
j) Make sure that the saw blade is fi tted in the correct direc-
tion of rotation. Do not grinding wheels or wire brushes
with the bench-type circular saw. If the saw blade is fi tted in-
correctly or accessories are used which are not recommended,
this could lead to serious injuries.
5) Additional safety information
1. Only use a saw blade which has the external diameter and hole
diameter specifi ed in the original operating instructions (“Techni-
cal data” section).
2. Use only blades with rotating speeds which are equal to or high-
er than the rotating speed marked on the power tool.
3. Use only a saw blade with a diameter which is the same as spe-
cifi ed on the saw.
4. Use the correct saw blade for the material you are working on.
5. Use only saw blades which are recommended by the manufactu-
rer which, if they are intended for cutting wood or similar materi-
als, comply with EN 847-1.
6. Only fi t blades which are well sharpened and have no cracks or
deformations.
Anl_TC_TS_2225_U_SPK7_Rewe.indb 62 24.03.2020 10:29:25

EINHELL TC-TS 2225 U Specifications

General

Product color	Red, Silver
Quick stop function	Yes
Idle speed	4250 RPM
Cutting height @ 45°	55 mm
Cutting height @ 90°	80 mm
Cross stop tilt angle range	-45 - 45 °
Input power	1800 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Saw blade type	Single
Number of teeth	48
Number of saw blades	1
Package depth	615 mm
Package width	715 mm
Package weight	28600 g

Weight and Dimensions

Depth	750 mm
Width	610 mm
Height	380 mm
Weight	17460 g
Table depth	555 mm
Table width	580 mm
Bore diameter	30 mm
Blade diameter	254 mm
Height adjustment range	0 - 80 mm