GB
- 64 -
23. Do not use this saw to cross-cut roundwood.
24. The machine is equipped with a safety switch to prevent it from
being switched on again accidentally after a power failure.
25. If you need to use an extension cable, make sure its conductor
cross-section is big enough for the saw‘s power consumption.
Minimum cross-section 1.5 mm².
26. If you use a cable reel, the complete cable must be pulled off
the reel.
27. Never load the machine so much that it cuts out.
28. Always press the workpiece fi rmly against the saw table.
29. Make sure that off -cuts do not catch on the saw blade crown.
Risk of catapulting!
30. Be sure to observe the safety information and operating and
maintenance instructions issued by the manufacturer, as well as
the dimensions listed in the Technical Data.
31. It is imperative to observe the accident prevention regulations in
force in your area as well as all other generally recognized rules
of safety.
32. Note the information published by your professional associa-
tions.
33. Operators must be at least 18 years of age.
34. Never remove loose splinters, chips or jammed pieces of wood
when the saw blade is running.
35. To rectify faults or remove jammed pieces of wood, always
switch off the machine fi rst. – Pull out the power plug –
36. Persons working on the machine should not be distracted.
37. Keep your workplace clean of wood scrap and any unnecessary
objects.
38. Before you use the machine for the fi rst time, check that the
voltage marked on the rating plate is the same as your supply
voltage.
39. Check the power cable. Never use a faulty or damaged power
cable.
40. Operate the saw only with a suitable vacuum extraction system
or a standard industrial vacuum cleaner.
Anl_TC_TS_2225_U_SPK7_Rewe.indb 64 24.03.2020 10:29:25
To Next Page
Loading...
Need help?
General
Weight and Dimensions
