GB
- 70 -
when the equipment is used as prescribed it is still impossible to
eliminate certain residual risk factors.
The following hazards may arise in connection with the machine‘s
construction and design:
•
Contact with the saw blade in the uncovered saw zone.
•
Reaching into the running saw blade (cut injuries).
•
Kick-back of workpieces and parts of workpieces.
•
Saw blade fracturing.
•
Catapulting of faulty carbide tips from the saw blade.
•
Damage to hearing if essential ear-muffs are not used.
•
Harmful emissions of wood dust when used in closed rooms.
4. Technical data
AC motor ............................................................ 220-240V ~ 50Hz
Power P .............................................S1 1800 W · S6 25% 2200 W
Idling speed n
0
................................................................ 4250 rpm
Carbide saw blade .....................................Ø 254 x Ø 30 x 2.4 mm
Number of teeth .......................................................................... 48
Table size .................................................................580 x 555 mm
Table width extension left/right .................................580 x 150 mm
Table length extension, width ............................................ 555 mm
Support surface max. .............................................830 x 1055 mm
Cutting height max. ...................................................... 80 mm / 90°
................................................................................... 55 mm / 45°
Height adjustment ............................................... infi nite 0 - 80 mm
Tilting saw blade ..................................................... infi nite 0° - 45°
Cross stop angle ..................................................infi nite -45° - 45°
Extractor connection ........................................................Ø 36 mm
Weight ................................................................... approx. 26.5 kg
Protection class: ...................................................................... II/
쓑
Thickness of the splitter ..................................................... 2.0 mm
Anl_TC_TS_2225_U_SPK7_Rewe.indb 70 24.03.2020 10:29:25
To Next Page
Loading...
