EINHELL TC-TS 2225 U User Manual

GB
- 71 -
Operating mode S6 25%: Continuous operation with idling (cycle
time 10 minutes). To ensure that the motor does not become exces-
sively hot, it may only be operated for 25% of the cycle at the speci-
fi ed rating and must then be allowed to idle for 75% of the cycle.
Danger!
Noise
The noise emission values were measured in accordance with EN
62841.
Operation
L
pA
sound pressure level ................................................ 93.2 dB(A)
K
pA
uncertainty ................................................................... 3 dB(A)
L
WA
sound power level ................................................ 106.2 dB(A)
K
WA
uncertainty ................................................................... 3 dB(A)
Wear ear-muff s.
The impact of noise can cause damage to hearing.
The stated noise emission values were measured in accordance
with a set of standardized criteria and can be used to compare one
power tool with another.
The stated noise emission values can also be used to make an initi-
al assessment of exposure.
Warning:
The noise emission levels may vary from the level specifi ed during
actual use, depending on the way in which the power tool is used,
especially the type of workpiece it is used for.
Keep the noise emissions and vibrations to a minimum.
•
Only use appliances which are in perfect working order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
Anl_TC_TS_2225_U_SPK7_Rewe.indb 71 24.03.2020 10:29:25

EINHELL TC-TS 2225 U Specifications

General

Product color	Red, Silver
Quick stop function	Yes
Idle speed	4250 RPM
Cutting height @ 45°	55 mm
Cutting height @ 90°	80 mm
Cross stop tilt angle range	-45 - 45 °
Input power	1800 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Saw blade type	Single
Number of teeth	48
Number of saw blades	1
Package depth	615 mm
Package width	715 mm
Package weight	28600 g

Weight and Dimensions

Depth	750 mm
Width	610 mm
Height	380 mm
Weight	17460 g
Table depth	555 mm
Table width	580 mm
Bore diameter	30 mm
Blade diameter	254 mm
Height adjustment range	0 - 80 mm