EINHELL TC-TS 2225 U User Manual

GB
- 72 -
•
Do not overload the appliance.
•
Have the appliance serviced whenever necessary.
•
Switch the appliance off when it is not in use.
Limit the operating time!
All stages of the operating cycle must be considered (for example,
times in which the electric tools are switched off and times in which
the tool is switched on but operates without load).
Caution!
Residual risks
Even if you use this electric power tool in accordance with in-
structions, certain residual risks cannot be rules out. The fol-
lowing hazards may arise in connection with the equipment’s
construction and layout:
1. Lung damage if no suitable protective dust mask is used.
2. Damage to hearing if no suitable ear protection is used.
5. Before starting the equipment
Before you connect the equipment to the mains supply make sure
that the data on the rating plate are identical to the mains data.
Warning!
Always pull the power plug before making adjustments to the
equipment.
•
Unpack the bench-type circular saw and check it for damage
which may have occurred in transit.
•
The machine has to be set up where it can stand firmly, e.g. on a
work bench, or it must be bolted to a strong base.
•
All covers and safety devices have to be properly fitted before
the machine is switched on.
•
It must be possible for the saw blade to run freely.
•
When working with wood that has been processed before, watch
out for foreign bodies such as nails or screws etc.
Anl_TC_TS_2225_U_SPK7_Rewe.indb 72 24.03.2020 10:29:26

EINHELL TC-TS 2225 U Specifications

General

Product color	Red, Silver
Quick stop function	Yes
Idle speed	4250 RPM
Cutting height @ 45°	55 mm
Cutting height @ 90°	80 mm
Cross stop tilt angle range	-45 - 45 °
Input power	1800 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Saw blade type	Single
Number of teeth	48
Number of saw blades	1
Package depth	615 mm
Package width	715 mm
Package weight	28600 g

Weight and Dimensions

Depth	750 mm
Width	610 mm
Height	380 mm
Weight	17460 g
Table depth	555 mm
Table width	580 mm
Bore diameter	30 mm
Blade diameter	254 mm
Height adjustment range	0 - 80 mm