EasyManuals Logo

EINHELL TC-TS 2225 U User Manual

EINHELL TC-TS 2225 U
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #73 background imageLoading...
Page #73 background image
GB
- 73 -
Before you actuate the On/Off switch, make sure that the saw
blade is correctly fitted and that the machine’s moving parts run
smoothly.
6. Assembly
Danger! Pull out the power plug before carrying out any
maintenance, resetting or assembly work on the circular saw!
6.1 Assembling the base frame (Fig. 3-4)
Danger! Make allowance for the weight of the machine and arran-
ge another person to help you if necessary!
Turn the bench-type circular over and set the saw down on the
floor or on some other work surface. Important! Place suitable
material (e.g. packaging material) between the table surface and
the surface on which it is stood to prevent any damage to the ta-
ble surface.
Important! Only fasten all the screw connections between the
base frame and machine loosely at first. Wait until you have re-
turned the bench-type circular saw to its working position before
tightening the screw connections securely. This is so that you
can be sure the base frame is aligned level with the surface on
which it is stood.
Use the hexagon screws (46) and washers (47) to fasten the four
legs (29) loosely to the saw.
Then use the lock bolt (48), washer (49), spring washer (50) and
nut (51) to screw the cross-struts loosely to the legs. Make sure
that the tongue-and-groove connection between the cross-strut
(30) and leg (29) engages properly.
Plug the rubber feet (13) onto the legs (29).
6.2 Assembling the table width extension (Fig. 5, 6)
Slot the table width extensions (33, 34) into the openings on the
left and right-hand sides of the saw table (1).
Slot the table length extension (35) into the openings on the back
Anl_TC_TS_2225_U_SPK7_Rewe.indb 73 24.03.2020 10:29:26

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EINHELL TC-TS 2225 U and is the answer not in the manual?

EINHELL TC-TS 2225 U Specifications

General IconGeneral
Product colorRed, Silver
Quick stop functionYes
Idle speed4250 RPM
Cutting height @ 45°55 mm
Cutting height @ 90°80 mm
Cross stop tilt angle range-45 - 45 °
Input power1800 W
AC input voltage220 - 240 V
AC input frequency50 Hz
Saw blade typeSingle
Number of teeth48
Number of saw blades1
Package depth615 mm
Package width715 mm
Package weight28600 g
Weight and Dimensions IconWeight and Dimensions
Depth750 mm
Width610 mm
Height380 mm
Weight17460 g
Table depth555 mm
Table width580 mm
Bore diameter30 mm
Blade diameter254 mm
Height adjustment range0 - 80 mm

Related product manuals