EINHELL TC-TS 2225 U User Manual

GB
- 74 -
of the saw table (1).
•
Then, using two recessed head screws (52) for each, secure the
table width extensions (33, 34) and the table length extension
(35) as shown in Figs. 5 and 6 to prevent them being pulled com-
pletely out.
•
Fit two locking screws (31) each to the left and right-hand sides
of the saw table (1) so that you can lock the table width extensi-
ons (33, 34) in a specific position.
•
Fit the two locking screws (32) to the back of the saw table (1) so
that you can lock the table length extension (35).
•
Important! A crosstip screwdriver is not supplied with the pro-
duct.
6.3 Standing the bench-type circular saw upright (2, 7-9)
•
Turn the machine over so that it stands on its legs.
•
The bench-type circular saw must be stood on a flat surface.
•
Then tighten all loose screw connections. Use both the wrenches
(38) and (39) to do this.
•
Screw the additional legs (37 to the rear legs (29) so that they
point towards the rear of the machine. Us the screws (54),
washers (49) and nuts (51) to fasten them.
•
Warning! Don not fit the additional legs (37) too far away from the
surface on which the machine stands; they are intended to provi-
de protection against tipping over.
•
Remove the screw (53) from the shaft (25).
•
Slide the hand wheel (8) and then the crank (10) onto the shaft
(25) as shown in Fig. 9.
•
Important! The shaft (25) and the crank (10) engage with a posi-
tive fit, i.e. the flat surface on the shaft (25) and the flat surface in
the hub of the crank (10) must lie on top of each other to enable
the crank (10) to be slid on.
•
Secure the hand wheel (8) and crank (10) with the screw (53).
Anl_TC_TS_2225_U_SPK7_Rewe.indb 74 24.03.2020 10:29:26

EINHELL TC-TS 2225 U Specifications

General

Product color	Red, Silver
Quick stop function	Yes
Idle speed	4250 RPM
Cutting height @ 45°	55 mm
Cutting height @ 90°	80 mm
Cross stop tilt angle range	-45 - 45 °
Input power	1800 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Saw blade type	Single
Number of teeth	48
Number of saw blades	1
Package depth	615 mm
Package width	715 mm
Package weight	28600 g

Weight and Dimensions

Depth	750 mm
Width	610 mm
Height	380 mm
Weight	17460 g
Table depth	555 mm
Table width	580 mm
Bore diameter	30 mm
Blade diameter	254 mm
Height adjustment range	0 - 80 mm