To Next PageTo Next PageWhat to do if Eizo FlexScan EV2451 Monitor says input signal is out of range?
If your Eizo Monitor displays the message that the input signal is out of the specified frequency range, check whether the PC is configured to meet the resolution and vertical scan frequency requirements of the monitor. You may also try rebooting the PC or selecting an appropriate setting using the graphics board’s utility.
What to do if my Eizo Monitor has no picture and the power indicator does not light up?
If your Eizo monitor shows no picture and the power indicator is off, ensure the power cord is properly connected. Then, turn on the main power switch located on the rear of the monitor. If the issue persists, turn the main power switch off, wait a few minutes, and then turn it back on.
How to fix incorrect display position on Eizo Monitor?
If the display position on your Eizo Monitor is incorrect, use the “Position” setting in the Setting menu to correct it. If the problem persists, use the graphics board’s utility, if available, to change the display position.
What to do if my Eizo Monitor has no picture and the power indicator is off?
If the power indicator on your Eizo Monitor does not light up and there is no picture, check whether the power cord is connected properly. Also, ensure that the main power switch on the rear side of the monitor is turned on. If the issue persists, turn off the main power switch, wait a few minutes, and then turn it on again.
What to do if the setting menu does not appear on my Eizo Monitor?
Check whether the switch operation lock function is active.
What to do if the message appears on my Eizo FlexScan EV2451 Monitor?
If a message appears on your Eizo monitor, verify that your PC is powered on and that the signal cable is securely connected. Try switching the input signal. If the issue continues, turn off the main power switch on the rear of the monitor, and then turn it back on.
What to do if my Eizo FlexScan EV2451 power indicator is lighting orange?
If the power indicator on your Eizo monitor is orange, try switching the input signal. Also, move the mouse or press any key on the keyboard. Check to make sure your PC is turned on. If none of these steps work, turn the main power switch on the rear of the monitor off and then on again.
Why is text blurred on my Eizo Monitor?
If the text on your Eizo monitor appears blurred, check that your PC is configured to meet the monitor's resolution and vertical scan frequency requirements. You can also try adjusting the “Sharpness” in the Setting menu.
How to fix incorrect display position on my Eizo FlexScan EV2451?
To correct an incorrect display position on your Eizo monitor, use the “Position” setting in the Setting menu to adjust the image position, specifically the “Hor. Position” and “Ver. Position”.
What to do if my Eizo FlexScan EV2451 Monitor power indicator is lighting white?
If the power indicator on your Eizo monitor is lighting white, increase the “Brightness”, “Contrast”, or “Gain” in the Setting menu.
General