Eizo FlexScan EV2457 - Functions of the Administrator Settings Menu

4-2. Functions of the “Administrator Settings” Menu
Function Setting Value Description
Auto Input Detection On
Off
This function automatically recognizes the connector through
which PC signals are input, and displays images on the
screen accordingly.
• “On”
When the monitor is connected to multiple PCs, if a
specic PC enters power saving mode or no signals
are input to the monitor, the connector is automatically
changed to another one to which signals are input.
• “Off”
This function displays the signal from the selected
connector regardless of whether a signal is input or not.
In this case, you can select the input signal to display
using the
operation switch on the front of the monitor.
For details, see “2-2. Switching Input Signals” (page
14).
Note
• When “Version 1.2” is selected for “DisplayPort” in the
“Administrator Settings” menu, the setting for “Auto Input
Detection” is automatically set to “Off”.
• This product automatically recognizes the connector
through which PC signals are input, and displays images
on the screen accordingly regardless of whether this
function is set to On or Off just after the main power
switch on the rear side of the monitor has been turned on.
However, this does not include the case when “Version
1.2” is selected for “DisplayPort” in the “Administrator
Settings” menu.
• When this function is set to “On”, the monitor only enters
the power saving mode when signals are not input from
any PC.
Compatibility Mode On
Off
If you want to avoid the following phenomena, set this function
to "On".
• The positions of windows and icons are shifted when the
monitor is turned off / on or has returned from the power
saving mode.
• Power Save function of the PC does not work normally.
• When the power to the monitor is turned off, a device
connected to the USB downstream port does not work.
Note
• When “Version 1.2” is selected for “DisplayPort” in
the “Administrator Settings” menu, the setting for
“Compatibility Mode” is automatically set to “On”.
26
Chapter 4 Administrator Settings