eka EKF 616 TC - Page 21

Electronic convection oven rev. 11 ________________MODD. EKF 616 TC – EKF 664 TC – EKF 711 TC – EKF 1016 TC
EKF 1064 TC – EKF 1111 TC – EKF 1664 TC – EKF 2011 TC
_________________________________________________________________________________________ page 21
3. DELTA T Value ( The core probe is not standard supplied but is an optional accessory)
1. TEMPERATURE IN COOKING CHAMBER
Use the keys and to increase or decrease the temperature (from 30°C to 260°C). After
that confirm the choice with the “SELECT” key.
With “BAKING IN PROGRESS”: the display shows the set temperature in the direction of the
symbol and the actual temperature detected in the cooking chamber in the direction of the
symbol .
2. CORE TEMPERATURE
Use the keys and to increase or decrease the temperature (from 0°C to 100°C). After
that confirm the choice with the “SELECT” key.
With “BAKING IN PROGRESS”: the display shows the set temperature in the direction of the
symbol and the actual temperature detected by the core probe in the direction of the
symbol .
When the OVERVIEW SCREEN shows the TEMPERATURE IN CHAMBER parameter and the
CORE TEMPERATURE parameter , to go back to setting the TIME parameter :
- Use the “STEP” key to select the CORE TEMPERATURE parameter .
- Use the “SELECT” key (the display shows the PARAMETER SCREEN);
- Use the “STEP” key to select the TEMPERATURE IN COOKING CHAMBER parameter ;
- Use the “SELECT” key.
At the end of these operations the display will show the red OVERVIEW SCREEN (if the
PREHEATING function is not set) to indicate the TIME parameter is missing (“00.00”).
3. DELTA T VALUE
Use the keys and to increase or decrease the temperature (from 0°C to 100°C). After that
confirm the choice with the “SELECT” key.
With “BAKING IN PROGRESS”: the display shows the set temperature in the direction of and
the actual temperature detected by the core probe in the direction of the symbol .
The display shows the set temperature in the direction of the symbol and the actual
temperature detected in the cooking chamber in the direction of the symbol .
When the OVERVIEW SCREEN shows the CORE TEMPERATURE parameter and the DELTA T
parameter , to go back to setting the TIME parameter :