eka EKF 616 TC - Possible Faults; Possible Alarms

TECNOEKA Srl ___________________________________________________________ operating and instruction manual
page 40 _____________________________________________________________________________________________
10 Possible faults
Type of fault
Cause of the fault
Corrective action
Control panel totally off
(the oven does not work)
- Non conforming connection to the
power mains
- Check connection to the mains
- Mains voltage not present
- Restore power supply voltage
- Electronic board protection fuse
(with microprocessor) blown
- Contact a skilled technician
Cooking cycle set and
“START” key activated: the
oven does not work
- Door open or ajar
- Close the door properly
- Magnetic sensor damaged
- Contact a skilled technician
Steam cycle activated: there
is no steam production in
the cooking chamber
- Non conforming water mains
connection
- Check connection to the water
mains
- Closed stopcock
- Check the cock
- Obstructed water inlet filter
- Clean the filter
- Damaged water inlet solenoid valve
- Contact a skilled technician
Closed door: steam escapes
through the gasket
- Non conforming gasket assembly
- Check gasket assembly
- Damaged gasket
- Contact a skilled technician
- Loosened handle "nose"
- Contact a skilled technician
The oven does not cook
evenly
- One of the motors is locked or
turns at low speed
- Contact a skilled technician
- The motors do not reverse direction
- Contact a skilled technician
11 Possible alarms
Type of alarm
Cause of the alarm
Effect
Corrective action
- Cooking chamber probe-
electronic board/microprocessor
connection interrupted.
- Disabled oven
operation
- Contact a skilled
technician
- Damaged cooking chamber
probe.
- Core probe-electronic
board/microprocessor
connection interrupted.
- It is not possible to
activate a cooking
cycle which requires
to set the "core
temperature"
parameter
- Contact a skilled
technician
- Damaged needle-shaped core
probe.
- Overheated motor (motor
thermal protection is triggered).
- Disabled oven
operation
- Contact a skilled
technician
- Active safety thermostat
- Disabled oven
operation
- Contact a skilled
technician
Temperature > 100°C
- The temperature in the cooking
chamber exceeds 100°C
- The automatic
washing cycle cannot
be activated
- Cool the cooking
chamber: open the door
and touch key to
activate automatic
cooling.