TECNOEKA Srl ___________________________________________________________ operating and instruction manual
page 20 _____________________________________________________________________________________________
4.3.3 Parameter setting
4.3.3.1 Cooking TIME setting (Parameter screen)
With the “STEP” key the following may be set:
1. TIME
2. PAUSE
3. MAINTENANCE
1. TIME
The parameter is settable from a minimum of 0h 01’ to 9h 59’ maximum. In the event of
MANUAL mode cooking cycle, in STEP 1 it is possible to also set an “INF” time (INFINITE):
The oven continues working until it is switched off by the operator.
2. PAUSE
This option may be set for a time between 0h 01’ and 23h 59’.
If the PAUSE is entered in STEP 1, it allows “DELAYED START” of the cooking cycle, which
is useful for foodstuff that needs to raise before cooking.
If the PAUSE is entered after STEP 1, it allows “thermal pressure” on the product to be
limited.
3. MAINTENANCE
This option makes it possible to maintain a constant temperature of 75°C within the
cooking chamber until the oven is switched off by the operator.
The PARAMETER SCREEN reads: “OFF”
use the key to enable this option (the display then reads ”ON”) which is
confirmed with the “SELECT” key;
use the key to disable this option (the display reads “OFF” again) which is confirmed
with the “SELECT” key.
When this option is active, at the end of the cooking cycle the display reads: “OVEN IN
MAINTENANCE”.
When the cooking cycle is active the display reads: “COOKING IN PROGRESS”
When the cooking cycle is in “PAUSE” the display reads: “BAKING STARTS IN” (count-down)
With “BAKING IN PROGRESS”
: the display shows the count-down of the set time in the direction
of the symbol and on the right the total time set of the cooking cycle (of 1 or more STEPS).
Important
The value of the set parameter may be confirmed immediately in the PARAMETER SCREEN
with the “SELECT” key; otherwise, the value is confirmed automatically after 5”.
4.3.3.2 TEMPERATURE setting (Parameter screen)
With the “STEP” key the following may be set:
1. TEMPERATURE IN COOKING CHAMBER
2. CORE TEMPERATURE (
The core probe is not standard supplied but is an optional accessory)
To Next Page
Loading...
