Need help?Do you have a question about the ELAC Uni-Fi 2.0 and is the answer not in the manual?
General| Nominal Impedance | 6 Ohms |
|---|---|
| Sensitivity | 85 dB |
| Max Power Input | 140 Watts |
| Tweeter | 1-inch Soft Dome |
| Midrange | 4-inch Aluminum Cone |
| Woofer | 5.25-inch Aluminum Cone |
| Cabinet Finish | Black Ash Vinyl |
| Speaker Type | 3-way |
| Frequency Response | 46Hz - 35kHz |
| Crossover Frequency | 200Hz / 2000Hz |
| Recommended Amplifier Power | 40-140 Watts per channel |
Connect speakers as instructed, use spikes/feet for leveling, ensure vertical alignment for stability.
Use appropriate gauge wire, ensure correct polarity, and strip ends properly for connection.
Attach outrigger feet using provided machine screws as shown in Figure A.
Screw in spikes. Use floor discs for hard floors. Handle carefully due to sharp ends.
Use allen wrench to adjust spike height until speaker is level and all spikes touch the floor.
Once level, use supplied covers to lock the spikes in position.
Place speakers 1-2 feet from walls/corners to optimize bass performance and avoid unnatural sound.
To Next Page
