21
6
6
.
.
2
2
.
.
1
1
.
.
E
E
N
N
G
G
I
I
N
N
E
E
O
O
P
P
E
E
R
R
A
A
T
T
I
I
O
O
N
N
The following instructions for engine operation are provided for information purposes only
and do not include all the details of engine operation and maintenance. For detailed
information see the operation instructions, supplied by the engine manufacturer, which are
included in the Owner’s Manual. Before operating the engine, you should familiarize yourself
with those instructions.
The warranty will be valid only provided the maintenance instructions are strictly observed.
For details see the enclosed instructions supplied by the engine manufacturer.
Before starting the engine:
Switch on the main engine switch.
Check and open the engine coolant water intake valve.
Check and open the fuel supply valve on the fuel tank.
Starting the engine:
Put the throttle into the idle position by pressing the button and shifting the handle
forwards/backwards - always away from any obstacles - by 30
o
(the engine is ready to be
started at appropriate throttle).
Press the button to start the engine. When the engine starts, release the button.
Back the throttle off to the idle (central) position and from that position move the
throttle up or down (without pressing the button) and the craft will move forwards or
backwards depending on the position of the handle.
Make sure all the warning lamps and sound alarm are off and the engine is adequately
cooled - check the coolant water pump function.
Stopping the engine:
Put the handle into the idle position and wait a few seconds for the engine to rotate at
the minimum RPM.
Press the button to shut-off the engine. When the engine stops, the warning lamps go on
and the sound alarm sounds.
CAUTION: - When sailing with inclination over 20 degrees, stop the engine.
- All fuel capacity can not be used. Make sure that the tank will be filled over
10 % of its capacity.
To Next Page
Loading...
