Elan 310 - SEA AND WASTE WATER SYSTEM

Owner’s Manual
27
 With an electrical spiral that can be turned on when the boat is connected to a 230V
supply.
CAUTION: - Do not operate the water heater if the fresh water system is empty.
- Do not turn the water heater on if the fresh water tanks are empty.
7
7
.
.
3
3
.
.
S
S
E
E
A
A
A
A
N
N
D
D
W
W
A
A
S
S
T
T
E
E
W
W
A
A
T
T
E
E
R
R
S
S
Y
Y
S
S
T
T
E
E
M
M
Sea water is used for flushing the toilets and as extra water for the sink (optional). The toilets
are flushed with a manual pump that is built into the toilet. The sea water for the sink is
pumped via foot pump. The waste water from the toilets and the wash basins in the toilets
and the sink is emptied via outlet seacocks.
CAUTION: - Never use the waste water pump with the outlet seacock closed.
- Never use any other but thin absorbent toilet paper and never too
much. Any other kind may damage the pump.
- Follow carefully the instructions for use and precautions marked on the
pump.
- If the pump breaks down, it will have to be taken apart and cleaned.
- The mechanism is maintained by rinsing the whole system with fresh
water. This is done by operating the pump.
- NOTE: Observe local regulation on discharge.
Figure 11
1. Galley sink outflow
2. Galley sink water seacock
3. Toilet sink outflow
4. Toilet sink water seacock
5. Waste water holding tank ~ 70 l
6. Holding tank air vent
7. Waste tank dockside suction
8. Toilet sea water inlet seacock
9. Toilet waste water seacock
10. Manual toile