Elan E4 - Closing Up Your Craft After Sailing Check List; Craft Identification and Builders Plate

3.7.
CLOSING UP YOUR CRAFT AFTER SAILING CHECK LIST
1.
Close all inlet/outlet seacocks in the hull.
2.
Turn off the electrical system.
3. Turn off the gas valve on
the gas bottle.
4.
Switch on bilge pump (if automatic) and pump the bilge.
5.
Close all the portlights and hatches.
3.8.
CRAFT IDENTICATION, BUILDER’S PLATE
The sailing yacht has mo
lded Craft Identification Number (CIN) visible on the starboard side
of the transom.
The duplicate CIN plate is fastened on inner
cushion.
The builder’s plate is readily visible, located in the cockpit, with the following information:
• Manufacturer’s name.
• The design category:
• T
he number of persons recommended by the manufacturer for which the craft is
designed.
• The CE mark.
ELAN E4 –
Owner's manual
14
CLOSING UP YOUR CRAFT AFTER SAILING CHECK LIST
Close all inlet/outlet seacocks in the hull.
Turn off the electrical system.
the gas bottle.
Switch on bilge pump (if automatic) and pump the bilge.
Close all the portlights and hatches.
CRAFT IDENTICATION, BUILDER’S PLATE
lded Craft Identification Number (CIN) visible on the starboard side
The duplicate CIN plate is fastened on inner
hull structure in the starboard
The builder’s plate is readily visible, located in the cockpit, with the following information:
A B C D
he number of persons recommended by the manufacturer for which the craft is
Owner's manual
CLOSING UP YOUR CRAFT AFTER SAILING CHECK LIST
lded Craft Identification Number (CIN) visible on the starboard side
hull structure in the starboard
cabine under
The builder’s plate is readily visible, located in the cockpit, with the following information:
he number of persons recommended by the manufacturer for which the craft is