Elan E4 - 230 V System

ELAN E4 – Owner's manual
34
7.6.2. 230V SYSTEM
The boat is optionally equipped with a 230 V electrical circuit. The socket is located in the
cockpit. In addition to the battery charger, the circuit also comprises sockets for 230 V
consumers.
Control panel for 230 V is located inside the locker at the chart table. When the boat is
connected to an external 230 V supply then green light is on. When water heater is in
function then also red light is on.
WARNING: Never work on electrical installation without disconnecting the power
supply. An electrical shock can cause fire.
Before connecting the cable on the shore, connect it to the boat first.
Disconnect the cable after use.
First switch off the main switch in the boat, then disconnect the cable on
the shore and last, disconnect it on the boat.
Do not soak the catches of the cable in water.
Do not modify any terminals of the electrical cable.
Never modify an electrical installation.
CONTROL PANEL 230V:
Figure 16