ELAN E4 – Owner's manual
20
6. PROPULSION SYSTEMS
6.1. SAILS AND MAST
Figure 7
6.2. ENGINE SYSTEM
CAUTION: Follow the instructions for the use supplied by the engine manufacturer,
especially with regards to the RPM and load of a new engine.
When shifting from one gear to another via the idle position, keep the
handle in the idle position long enough for the engine to rotate at the
minimum RPM.
Check the engine oil level.
When putting in the reverse, hold the steering wheel firmly to avoid
breaking the steering system.
Shut down the engine before opening the engine compartment. The
engine has rotating and moving parts that can be dangerous.
Never switch the main engine switch or turn-key when engine is running.
Do not operate the starter for more than 10 seconds at a time. If the
engine does not start, wait for at least 30 seconds before next try.
Each engine has its critical RPM which is indicated by an increase in engine
vibrations. You should always avoid this speed.
Mainsail: 30,00 m
Jib: 28,60 m
2
Gennaker: 110,00 m
2
To Next Page
Loading...
