ELAN E4 – Owner's manual
42
9. MAINTENANCE
9.1. HAULAGE
Figure 19
CAUTION: Look for labels on the boat to place the lifting stripes (see Fig.19).
Make sure the straps do not damage the propeller or sail-drive and
transducers.
DANGER: It is not allowed to stay on board or stand under the boat when the boat
is being hauled out.
Make sure that the lifting straps meet all the safety requirements and
that they are not damaged.
9.2. UNDERWATER STRUCTURE
9.2.1. HULL
An antifouling protects the underwater structure against fouling by marine growths that run
down the performance and sailing ability of the boat. It is applied on the hull section that is
immersed in water and up to about 100 to 150 mm above the waterline or up to the top
stripe. It needs to be serviced at least once a year.
For a new boat it is very important to observe the following steps:
Use a 95% proof alcohol to remove all traces of the mould release agents and then wipe with
absorbent paper or cloth.
To prepare the hull for the antifouling, gently sand it with sandpaper (400 grade).
Rinse thoroughly with cold fresh water without applying pressure or detergent and allow it
to dry.
Apply the antifouling with a spray gun or a roller in accordance with the antifouling
manufacturer’s instructions.
To Next Page
Loading...
