MEDIBURN30 11 D-115 Rev 010
www.elastec.com
DOOR LOCK MOTOR ASSEMBLY
The door lock motor assembly is located on the right side of the burner
compartment. It is designed to lock the burn chamber door as soon as the
START button is pushed. The door-locking system is designed as a safety
feature and is built in such a way that, if tampered with, the MediBurn30 will not
start. When the burn chamber door is open, the controller scrolls “door open,”
and if the burn chamber door is opened during the burn cycle, the unit will
automatically cycle into cool mode and the unit will have to cool to 300C before
restart can begin.
NOTE: The MediBurn30 must always be cooler than 300° Celsius (572°
Fahrenheit) before trying to load unit.
To Next Page
Loading...