Elcontrol Microvip 3 plus - Page 57

52
- Phase L3 active power (W)
- Phase L1 cosø
- Phase L2 cosø
- Phase L3 cosø
- Phase L1 reactive power (VAr)
- Phase L2 reactive power (VAr)
- Phase L3 reactive power (VAr)
- Phase L1 apparent power (VA)
- Phase L2 apparent power (VA)
- Phase L3 apparent power (VA)
- 6 ASCII characters = 30 Hex
- 6 ASCII characters = 30 Hex
- 6 ASCII characters = 30 Hex
- Three-phase apparent power (VA)
- Three-phase reactive power (VAr)
- Frequency (Hz)
- Positive three-phase kWatthours (single-phase if single-phase is set) (kWh)
- Positive three-phase kVArhours (single-phase if single-phase is set) (kVArh)
- Three-phase average reactive power (single-phase if single-phase is set) (VAr)
- Three-phase average apparent power (single-phase if single-phase is set) (VA)
- Three-phase average active power (single-phase if single-phase is set) (W)
- Three-phase apparent power peaks (single-phase if single-phase is set) (VA)
- Three-phase active power peaks (single-phase if single-phase is set) (W)
- Negative three-phase kWatthours (single-phase if single-phase is set) (kWh) (if Delta system
is selected, or Star system or single-phase switching with the Cogeneration 4 option
- Negative three-phase kVArhours (single-phase if single-phase is set) (kVArh) (if Delta system
is selected, or Star system or single-phase switching with the Cogeneration 4 option
5 ASCII charcters = 30 Hex
1 ASCII character = 30 Hex
- WITH SINGLE-PHASE OPTION SELECTED:
the string is always 65 words long. The three-phase measurement and that of phase L1 coincide.
The measurements of phases L2 and L3 are not calculated.
DATA AND HOUR READING
This is carried out by reading 3 words starting from address 0DFCH.
The meaning of the 6 bytes received is as follows:
- Minutes
- Hours
- Day
- Month
- Year
- Datum to be rejected (1 byte)
NOTE: All the data received are in BCD.