Viewing the EPROM Revision Level 16
Advanced Screens 16
Setting the Home Position Offset 16
Setting the Output Function 17
Setting the High/Low Pressure Limit Shutdown 17
Setting the Motor Stall Shutdown 17
Setting the Error Delay 18
Setting the Save State 18
Setting the Save in Run Flow Rate 18
Setting the Contact Closures during Remote Analog Mode 19
Viewing the Stroke Length 19
Zeroing the Pressure Transducer 19
Pump Limits 20
Viscosity Limits 20
Chemical Limits 20
Mechanical Limits 20
Temperature Limits 20
Shutdown Procedures 20
IV. MAINTENANCE 21
Cleaning 21
Piston Seals 21
Replacing The Piston Seal 21
Replacing Valves 23
Removal Of Existing Valves 23
Installation Of New Valves 23
Replacing Valve Cartridges 23
Troubleshooting 25
V. SPARE PARTS AND ACCESSORIES 26
For 3/32” Stainless Steel Pumps 26
For 1/8” Stainless Steel Pumps 27
For ¼” Stainless Steel Pumps 28
For 3/32” PEEK Pumps 29
For 1/8” PEEK Pumps 30
For ¼” PEEK Pumps 31
For 1/8” Hastelloy C-276 Pumps 32
For ¼” Hastelloy C-276 Pump 32
VI. APPENDIX 33
RS232 33
Warranty 34
To Next Page
Loading...