EasyManua.ls Logo

Electra DNC series - CONTROL SYSTEM; Electronic Control Package Configuration

Electra DNC series
153 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8-1
CONTROL SYSTEM
Revision Y05-01Service Manual - DNC Series
8. CONTROL SYSTEM
Instructions for
Electronic Control Service Package
INTRODUCTON
The electronic control package is designated for service and is common for the following
group of air-conditioners.
1. ST/RC group - Cooling only / Cooling and Heating by heat pump.
Cooling and Heating by heat pump and supplementary heater.2. SH group -
3. RH group - Cooling and Heating by heaters only.
Before installation , be sure that you select and set for the right group .
PACKAGE CONTENT
The following should be included in the electronic control service package:
- Controller designated for service
- Model plug
MODEL PLUG SETTINGS
Before installation, make sure to set the model plug to conform with the suitable group.
GROUP J6 Setting J2 Setting
ST / RC open open
SH closed open
RH closed closed

Table of Contents

Related product manuals