ELECTRO FREEZE CS700-FG - Draining Product from Freezer

ELECTRO FREEZE Shake Model CS700-FG
185231-17 23
9.2 Draining Product from Freezer
NOTE: It is your responsibility to be
aware of and conform to the requirements
for meeting local, state, and federal laws
concerning the frequency of cleaning and
sanitizing the freezer.
To remove frozen product from the
cylinder, perform the following steps:
1. Place a clean, sanitized
container under the dispensing nozzle.
2. Remove the mix feed tube from
the hopper. (See gure 9-3.
3. Turn the selector switch to the
“CLEAN” position.
4. Dispense the product until the
mix hopper is empty. Turn the selector
switch to “OFF” position and drain the
remaining product. Close the plunger. If
franchise and local health codes permit,
cover the rerun product container and
place in a cooler. (See 10.2 General
Information - Rerun).
5. Pour 2 gallons of cold water
into the hopper. Turn the selector switch
to “CLEAN” and dispense the cold water.
Important:
DO NOT use hot water. Damage to the
freezer could occur.
6. Follow with 2 gallons of
warm water and repeat until the freezer
dispenses clear water. With most of the
water dispensed, place selector switch
in the “OFF” position and drain the
remaining water.
7. Prepare sanitizing solution
in a container. Sanitizing solution must
be mixed according to manufacturer’s
instructions to yield 100 ppm available
chlorine solution.
8. Pour all the sanitizing solution
into the hopper pan. Using a clean brush
scrub the hopper walls.
9. Turn the selector switch to the
“CLEAN” position and allow the beater to
run for 5 minutes.
10. Place an empty container
under the dispensing head. Drain the
sanitizing solution from the cylinder by
slowly pulling down on the dispense
handle. Open and close the handle
several times while draining.
11. With most of the sanitizing
solution drained, turn the selector switch
to the “OFF” position and drain the
remaining sanitizer from the freezer and
close the plunger.
12. Proceed to disassembly,
cleaning and sanitizing instructions.
Figure 9-3
Tube-Mix Feed
O-Ring
O-Ring
Insert-Assy. Mix
Feed