- 12 -
Presets
The Presets menu handles all things presets. To enter the submenu for the
highlighted function, push the NavCoder to the right.
Save Preset: while Save Preset is highlighted, push the NavCoder to the right.
The POG3 immediately saves the current settings to the currently selected
preset number.
Helpful Hint: Possibly the quickest way to save a preset from a home screen
is to push the NavCoder D-Pad in the following sequence: up, right, right.
Preset saves immediately.
Edit Name:
the NavCoder, then push the NavCoder downward to edit the name.
1. For each character position, rotate the NavCoder in either direction to
cycle through the list of available characters.
2. Push the NavCoder right or left to advance to the next or previous character.
3. A downward push on the NavCoder changes the character to a space.
4. Once the name is ready, perform a center press and hold on the NavCoder
for just over a second, until the screen displays Preset Name Saved.
Copy Preset: copy a preset to a different preset location.
1. Upon entering the Copy Preset-
ing you to choose the source preset by rotating the NavCoder in either
direction.
2. Once the source preset is chosen, move the NavCoder in the downward
direction to choose the destination location. Again, turn the NavCoder
in either direction to choose the location.
3. When you’re ready to copy the preset, press and hold the NavCoder with
a center push to initiate the preset copy.
4. If you are copying to an occupied preset location, the display will ask
OVERWRITE EXISTING PRESET? Choose OK or CANCEL.
Swap Presets: allows two presets to swap their locations.
1. Enter the submenu and choose the A preset by rotating the NavCoder in
either direction.
2. Push downward on the NavCoder, and then choose the B preset.
3. Press and hold the NavCoder center push for just over one second.
The display will show Presets Swapped.
Erase Presets: allows for deleting a preset.
NavCoder to choose the preset to erase.
To Next Page
Loading...
