What to do if Electro-Voice speaker sound is distorted and the front LED is OFF, LCD screen LIMIT is ON?
If the sound from your Electro-Voice speaker is distorted, the front LED is off, and the LCD screen shows LIMIT is on, it is likely due to excessive input level. Reduce the input level or loudspeaker level knobs to prevent limiting.
What to do if Electro-Voice speakers have intermittent output with cracking or distortion?
If your Electro-Voice speakers experience intermittent output with cracking or distortion, a faulty connection is the likely cause. Check all connections at the amplifier and loudspeakers to ensure they are clean and tight. If the problem persists, check the wiring.
Why is there no sound produced with microphone connected to INPUT 1 or INPUT 2 on my Electro-Voice speaker?
If no sound is produced when a microphone is connected to INPUT 1 or INPUT 2 on your Electro-Voice speaker, consider the following: * **Phantom Power Requirement:** If the microphone requires phantom power, use a dynamic microphone that does not, or use an external phantom power source. * **Input Gain Knob Position:** Ensure the input gain knob is in the MIC position. Slowly increase the input gain knob level to engage the microphone pre-amp.
How to stop acoustic feedback from Electro-Voice EKX-15SP Speakers when using a microphone?
To reduce acoustic feedback from your Electro-Voice speakers when using a microphone, consider the following: * **Incorrect Gain Structure:** Reduce the microphone levels at the mixing console or input source. If the microphone is connected directly to the speaker, reduce the input level on the speaker. Positioning the microphone close to the sound source increases gain-before-feedback. * **MODE Setting:** Change the MODE to LIVE or SPEECH. * **Microphone Position:** Whenever possible, set up the loudspeakers so the microphone is behind them. If using the loudspeaker in a monitor position, aim the loudspeaker to the back of the microphone.
General| Subwoofer type | Active subwoofer |
|---|---|
| Subwoofer driver diameter | 381 mm |
| Subwoofer frequency range | 40 - 180 Hz |
| XLR in | Yes |
| Material | Wood |
| Product color | Black |
Weight and Dimensions| Subwoofer depth | 551 mm |
|---|---|
| Subwoofer width | 530 mm |
| Subwoofer height | 455 mm |
| Subwoofer weight | 26200 g |
To Next Page
