Electro-Voice EVOLVE - Page 34

34 en | Mixer operation EVOLVE Portable Column Loudspeaker
2019-08 | 01 | Installation manual Electro-Voice
Menu item Subitems/parameter range
(default setting in bold)
Description
affected by the MASTER A control’s
setting. When MASTER B is set to
Post, the audio signal is tapped
post MASTER A volume control and
therefore affected by the MASTER A
control’s setting. This mode is
mainly used for subwoofers or
delay lines.
When MASTER B is set to Stereo,
the MASTER B L/R signal is not
changed and outputted in stereo.
When Mono is selected the
MASTER B L/R signal is summed
and outputted in mono at MASTER
B L and also MASTER B R.
– MAS. B Delay: : 0.0-50
Meters
The MASTER B signal can be
delayed up to 145.8 ms. The unit
can be switched between
milliseconds (ms), meters and feet.
OUTPUT SETTINGS – DIRECT DRIVE: Off,
On/50Hz HPF, On/70Hz
HPF
– AMP ROUTING: MASTER A,
MASTER B, AUX, Dual A - B,
Dual A - AUX, Dual B - AUX
– AUX Mode: AUX-Bus, MAS.
A Pre, MAS. A Post
Limiters:
– MASTER A: -10 - +11 dBu
– MASTER B: -10 - +11 dBu
– AUX Limiter: -10 - +11 dBu
In this menu you can configure
advanced features of the EVOLVE
column speaker outputs. Please
refer to the corresponding sections
for more details:
– 100 V Direct Drive
– Amplifier routing
– AUX sources
The audio limiter thresholds can be
set independently for the MASTER
A, MASTER B or AUX output signals.
DEVICE SETUP 1 – LCD Auto Dim: Off-60 Min.
– Dim Brightness: 0-100%
After the time set here the display
brightness is dimmed. The
brightness of the display in dimmed
mode can be adapted to the
installation location.
– Screensaver: Off-60 Min.
(default: Off)
– Personalize
After the time set here the
screensaver is activated. You can
personalize the device name shown
in the screensaver screen.
DEVICE SETUP 2 – Lock/Unlock: 0000-9999
– Lock Mode: Custom, Level
1,2,3
Enter a 4 digit PIN (password) to
lock certain parameters of the
EVOLVE column speaker. Please
refer to section Locking for more
details.