Power save mode helps energy to be saved by turning the display off while the oven doesn't work for long time.
If the oven is left for 10 minutes without user's touch on a button and dial, Power save mode will work automatically to turn the display
off. The power save mode could be cancelled when you press any button, turn a dial or open the door during the power save mode.
POWER SAVE MODE
You may lock the control panel to prevent the oven from being accidentally started or used by children.
To lock or unlock the controls, press and hold the Stop button for about 3 seconds.
While the control panel is locked, “Loc” will be displayed briefly when any button is pressed.
ChILD LOCK
To remind you that you have food in the oven, the oven will display “End” and beep once a minute for 5 minutes until you either open
the oven door or press any button.
REMINDER
1. Open the door.
• Oven stops operating.
• You can restart the oven by closing the door and touching START COOK button.
2. Press the STOP button.
• Oven stops operating.
• If you wish to cancel the cooking settings, press the STOP button again.
TO STOP ThE OVEN WhILE ThE OVEN IS OPERATING
If you see arcing, press STOP button and correct the problem.
Arcing is the microwave term for sparks in the oven. Arcing is caused by:
• Metal or foil touching the side of the oven.
• Foil not molded to food (upturned edges act like antennas).
• Metal, such as twist-ties, poultry pins, or gold rimmed dishes, in the microwave.
• Recycled paper towels containing small metal pieces being used in the microwave.
ARCING
ABNORMAL MESSAGE
• If the inside temperature of the oven is higher than expected or
the temperature sensor doesn't work properly, “Err 2” message
will be shown in the display.
• Unplug the power and call our technical service.
• When the temperature sensor is disconnected, “Err 3” message
will be shown in the display.
• Unplug the power and call our technical service.
To Next Page
Loading...
