Electrolux EUCAIWHGUK User Manual

DOC. NO. 5956.65J.00 P. 23 / 174
EFS - Dishwashing Systems Platform
Electrolux Professional
To do this, wait for the water softener to finish previous resin washing or regeneration operations and set the
parameter
( family) to  for regenerating column A or to  for regenerating column B.
Switch the machine off and on again so that it carries out complete regeneration of the set column. If previous
resin washing or regeneration operations were not completed, the manual request for regeneration is not car-
ried out.
It is possible to check which column is being used for boiler filling by querying the parameter
 ( fam-
ily): if
 = 0 column “A” is used, if  =1 column “B” is used.
The number of litres used by the machine can be checked by querying the parameters
 (m3 ) and 
(litres). To calculate the total number of litres used by the machine, add the  and  values.
NB: In machines with incorporated continuous water softener, tank filling must be done through subsequent
rinses from the boiler and cannot occur by overflow since the filling system does not allow overflow in the tank.
Therefore, even if the parameter
 is set to , filling is done by subsequent rinses..
9.5 HOOD-TYPE DISHWASHER WITH CYCLE THERMAL LABEL
WARNING:
Functions present with firmware version 4.04.
If the parameter  (Thermal Label enabled) of
the family  is set to , the "Endless cycle"
button has the "endless cycle" function and the
"high productivity" mode is non-settable.
If the parameter  (Thermal Label enabled) of
the family  is set to , the "Endless cycle"
button does not have the "endless cycle" function
but that of the "high productivity" mode.
This means that the machine can work in 2 modes,
"high productivity" and "Thermal Label". When the
machine is set in "high productivity" mode, the
parameters which define the cycle times and
temperature set points are the standard
parameters, whereas when the machine is set in
"Thermal Label" mode, the parameters are
dedicated (they are new parameters listed below).
The mode Thermal Label provides for cycle times,
tank hysteresis and tank and boiler temperatures
such as to pass the "Thermal Label" test.
Press and hold down the button to switch the
machine from "high productivity" mode to "Thermal
Label" mode and vice versa.
The "high productivity" button LED is off when the
machine is set in "Thermal Label" mode (factory
default) and lights up when the button is pressed
and the machine is configured in "high productivity"
mode. Whenever the machine is shut down, it
memorises the mode with which is was switched off
and reloads it when switched on the next time.
New parameters:
•  (family ): if set to  it enables the
Thermal Label mode (and disables the “endless
cycle” button).
•  (family ): temperature set point for the
boiler during the cycles Thermal Label.
•  (family ): temperature set point for the
tank during the cycles Thermal Label.
•  (family ): hysteresis temperature for
the tank during the cycles Thermal Label.
•  (family ): long wash time for cycle 1 in
Thermal Label mode.
•  (family ): short wash time for cycle 1
in Thermal Label mode.
•  (family ): long wash time for cycle 2 in
Thermal Label mode.
•  (family ): short wash time for cycle 2
in Thermal Label mode.
•  (family ): long wash time for cycle 3 in
Thermal Label mode.
•  (family ): short wash time for cycle 3
in Thermal Label mode.
9.6 DISHWASHERS WITH WASH TANK WATER CHANGE FREQUENCY CONTROL
WARNING:
Function included starting from firmware version 5.00.

Electrolux EUCAIWHGUK Specifications

General

Brand	Electrolux
Model	EUCAIWHGUK
Category	Dishwasher
Language	English