- 32 -
DGS-TDS-N07.2003 C.D. 599 51 74-13 EN
The last alarm code can be displayed even if the programme selector is not in the 10th position
(service test mode) or if the appliance is in normal operating mode (e.g. during the execution of an
washing programme):
- Press and hold down buttons S1 and S2 simultaneously for at least 2 seconds: the LEDs
initially switch off, and then display the flashing sequence corresponding to the alarm.
- The alarm sequence continues as long as the two buttons are held down.
- The alarm reading system is as described in paragraph 10.2
- While the alarms are displayed, the appliance continues to perform the cycle or, if in the
programme selection phase, maintains the previously-selected options in memory.
10.4 Cancelling the last alarm
- Enter service test program (see page 29)
- Press and hold down button S1 and S2 simultaneously for at least 2 sec.
It is good practice to cancel the last alarm:
- after reading the alarm code, to check whether the alarm re-occurs during diagnostics
- after repairing the appliance, to check whether it re-occurs during testing.
10.3 Rapid reading of alarm codes
To Next Page
Loading...
