- 7 -
DGS-TDS-N07.2003 C.D. 599 51 74-13 EN
- Easy-Iron
- In COTTON-programmes:
- adds three rinse cycles
- eliminates the intermediate spin cycles
- performs an impulse spin phase
- adds an untangling phase after the spin cycle
- In SYNTHETICS-cycles:
- reduces the heating temperature in 50/60° cycles to 40°C
- increases the washing time
- prolongs the cooling phase at the end of the washing phase
- addds one rinse
- adds an untangling phase after the impulse spin cycle
- Reduced spin speed
- Reduces the speed of all spins as shown in the table:
- Rinse-hold
- Stops the appliance with water in the tub before the final spin cycle.
- To drain the water, reset the programme and then select a drain or spin cycle.
- Delayed-start time
- Adds a pause before the start of the programme. The delay time is displayed on the
corresponding LEDs.
- To start the cycle immediately after selecting a delayed start:
- press START/PAUSE, cancel the delay time by pressing the appropriate button, then press
START/PAUSE again.
0D[LPXPVSLQVSHHG USP
5HGXFWLRQIRU&27721USP
5HGXFWLRQIRU$//27+(5&<&/(6USP