Service
Manual
9406
Repair instructions
Checking the adjustment of the unbalance cutout
• When the machine is empty, check that the
operating arm of the unbalance cutout is situated 5
mm under the centre of the sensor. If necessary,
adjust by
– moving the sensor
– carefully bending the attachment plate of the
microswitch.
Unbalance cutout switches off several times
• Unsuitable batch of washing.
• Unbalance cutout incorrectly adjusted, see above
mentioned check.
• Inferior shocks absorbers, see "43. Frame".
28. Unbalance cutout
28
2
Fas
Imbalance
cutout
Breaking
contact
imbalance relay
Coil
imbalance
relay
Imbalance cutout
To Next Page
Loading...
